Aerosol Cone (Straight) Induction Port Delivery Tool (TN75675)

FOR GASOLINE INDUCTION:

① Remove the best location sensor and insert the (TN75675) aerosol cone straight delivery tool firmly into the open induction port.  Confirm port has good vacuum, is centrally located and close to the throttle body.

② Attach the TN75490 tool to the aerosol product by pushing the push-to-connect union onto the 1/4″ OD dispenser tip.

③ Start the engine with the vehicle in Park or Nuetral and adjust engine speed to 1200-2000 RPM. Spray the product in short bursts so as to not stall the engine.  If the engine will not run well, shut off and remove the electrical connection then restart the engine.

④ Continue to run the engine for (2) minutes after the can is empty.

⑤ Remove tool from can by pulling back on the union’s latching collar.

WYNN’S DE-CARBON FOAM:

① Requires use of 1/4″ OD dispensing. Use throttle stick or AffinityEG ADTEH Extension Hose assembly to control engine RPM.

② For best results use Wynn’s Job Aid for recommended service procedure.