Aerosol Twin Turbo Dual Port Delivery Tool (TN75017)

FOR FUEL INDUCTION:

① Remove the dual sensors and install the TN75017 dual plug tool into the induction ports. Secure with the same sensor screws. Be sure to note which sensor came from which port.

② Attach the TN75017 tool to the aerosol by pushing the push-to-lock union onto the 1/4″ OD dispenser tip.

③ Start the engine with the vehicle in Park or Nuetral and adjust engine speed to 1200-2000 RPM. Spray the product in short bursts so as to not stall the engine. If engine does not run well, shut off and remove electrical connections from the sensors and restart.

④ Continue to run the engine for (2) minutes after the can is empty, then remove the tool and re-install the two sensors in the same ports they were removed from.

⑤ Remove tool from can by pulling back on the union’s latching collar.

WYNN’S DE-CARBON FOAM:

① Requires use of 1/4″ OD dispensing. Use throttle stick or AffinityEG ADTEH Extension Hose assembly to control engine RPM.

② For best results use Wynn’s Job Aid for recommended service procedure.