Flexible Throttle Body ‘S’ Tool 0.85 GPH Nozzle (31608S)
$123.50
The flexible throttle body ‘S’ tool is used to perform a gasoline fuel induction service through the throttle body with the fresh air boot on or removed. The 0.85 GPH nozzle is a multi-purpose flowrate and provides good induction service for common engine sizes.
Throttle Body Tool for:
Fuel Service Tool
(FST16 and FST24 #31608S)
RECOMMENDED CLEANERS
BY WYNN’S
- Most flexible induction tool design allows induction service to be performed with the fresh air boot in place or removed for visual inspection during the service
- Designed to interchange with multiple nozzle options for the Flexible Throttle Body Arm
- Rectus male connector machined in the body
- Spray nozzle tips can be removed for cleaning or replacement
Flexible Throttle Body Nozzle Tool Sets:
31606B – 0.65 GPH Nozzle
31608B – 0.85 GPH Nozzle (Standard)
Nozzles Only:
31606N – 0.65 GPH Nozzle
31608N – 0.85 GPH Nozzle (Standard)
Flexible Throttle Body ‘S’ Tool Sets:
31606S – 0.65 GPH Nozzle
31608S – 0.85 GPH Nozzle (Standard) – THIS PRODUCT
Induction ‘S’ Tool Only:
31606A – 0.65 GPH Nozzle
31608A – 0.85 GPH Nozzle (Standard)
Additional information
Weight | 0.4 lbs |
---|
Service Instructions
FOR FUEL INJECTION:
① Depressurize tool before removing fill cap. Fill with injection cleaner.
② Attached required fuel injection adapter to vehicle and service tool. Disengage vehicle fuel pump.
③ Set tool pressure required for engine. Open service hose valve and start engine. Run all cleaner until engine stops.
④ Remove tool & fuel injection adapter. Re-engage fuel pump.
FOR FUEL INDUCTION:
① Depressurize tool before removing fill cap. Fill with injection cleaner.
② Attach “S” Tool or Flex Nozzle Tool for induction service.
③ Close service hose valve and set tool pressure to 60 psi.
④ Install “S” tool in fresh air tube at throttle plate, or set Flex Nozzle Tool from throttle plate with fresh air tube removed (disconnect MAF sensor).
⑤ Run service on warm engine at 1200 RPM. Blow out 3-4 times during service to strip soot/carbon and clear induction system.
⑥ After service, run 10 min. then drive briskly to clear induction system.
⑦ Reconnect MAF sensor and clear any engine codes.
Only logged in customers who have purchased this product may leave a review.
Reviews